Perhaps you have got a few Teeshirts that are very worn out and not even worth giving away. You could rip them up and use them as cleaning rags, or you can try extending their usefulness by braiding them into a nifty rug, old-school style!
I actually tried making a similar rug earlier this year using old towels, but sewing the towel braid together hurt my fingers – and the rug didn’t hold together as well as I liked.
Using old teeshirts for this braided rug worked better for me, because the braid was easier to work with, and I could weave the rug together – no fussing about with needles and other pointy hurty things. This craft turned out to be straightforward enough for Little E to do it on her own! We ended up with a lovely, soft rug which made a great bathmat – and it’s washable too.
In this tutorial, I use a four strand braided technique (like a ‘fishtail’ braid), because I feel this gives a wider and flatter weave, but you can use a three stranded braid if you feel that a puffier rug works for you.
How to make an Old-School Braided Rug from Old Teeshirts
- Old Teeshirts (I used about 3 large men’s tees to make a round floormatbut you can use more if you want a bigger rug)
- Cut the tees into 1.5-2 inch strips widthwise so that you end up with a bunch of loops
- Stretch the loops as far as they will go until the fabric rolls in on itself
- Cut the loops open on one end so that you are left with long strings
- Choose 4 strings and knot them together. I decided to go with 2 strings of contrasting colours to get a nice chevron pattern.
- Cross the outer (green in the picture above) strings over each other, right string over the left to form an X.
- Take the next set of outer strings (dark blue in the picture above). Cross them over the centre of the braid, right over left, to form a second X.
- Take the following set of outer strings (green) and cross them in the centre again, right string over left, to form a third X. You are now back to your original position, having done three layers of braiding!
- After you have done about 4-5 inches of braid, roll the braid into a spiral, with the original knot in the spiral centre. Now you can weave the free braid together to form the rug.
- Take the string that is closest to the centre of the spiral and pass it through one of the loops of braid that it is nearest to it (see the picture below).
- Pull the string tight to secure the free section to the rest of the rug.
- Continue to braid, securing each section every 1.5-2 inches.
- When the lengths of string become too short to braid, you can add another string to it by knotting the ends together. To make a less bulky knot, snip a small hole about 0.5 inches from the end of both strings that you wish to join together.
- Pass the end of the old string through the hole in the new string.
- Then, push the other end of the new string through the hole in the old string
- Pull tight and it should form a small, tight knot!
- Continue braiding your rug until it reaches a size that you are happy with
- To finish off the rug, knot the ends of the free braid to one of the loops from the braid next to it, securing the end of the braid to the rest of the rug. You can then trim off any excess string or tuck the strings into the rest of the rug to make them neat.
- Enjoy your soft new floormat!